Alarm system and burglar alarm

AN-05 is a GSM antenna with 800-2100MHz. + 4dB. It is a long pole antenna that has an extension coil on a magnetic base. The antenna must be used to move the receiver position too centrally, to a place with better signal strength, and thus does not have appreciable gain.

Specifications:
Cable length of 3 m
SMA plug
Length 26 cm
Possibility of extension 2m, 5m Coax cable RG-58U
Mounting magnet

AN-06 is a self-adhesive print antenna in plastic packaging.

It is made to be mounted in a plastic box, next to the transmitter module.

Specifications:
Cable length of 30 cm
SMA plug
Length 26 cm
No possibility of extension
Self-adhesive mounting

Test unit that can be used for simple testing of glass break detector.

JS-7904 is a corridor lens for Jablotron's JA and JS PIR detectors. It has a range of 25 meters.

Also note that the lens is not compatible with Jablotron's JA-111P xx and JA-151P xx series.

JS-7910 is a lens for Jablotron's JA and JS PIR detectors. The lens is for people with pets, so the PIR detector is not disturbed by the pet's movements on the floor. If you install it at a height of 2.5 meters, there will be a free area 7 cm above floor level 7 meters outside.

Please note that the lens is not compatible with Jablotron's JA-111P xx and JA-151P xx series.

JS-7902 is a curtain lens for Jablotron's JA and JS PIR detectors.

Please note that the lens is not compatible with Jablotron's JA-111P xx and JA-151P xx series.

LD-81 is a water damage detector that is placed in risk areas, eg under the kitchen sink, or other places where water leaks may occur. Using the detector, water leaks can be detected before the situation escalates and permanent damage occurs. The operating temperature of the detector is -10 to + 40 ° C.

The LD-81 detector works with one of the universal transmitters for either JA-100, Oasis or Profi. It does not need a power supply, but is connected to the JA-105M / JA-81M / JA-16N magnet, which acts as a transmitter to the control panel.

Magnetic disk (and associated screw) that can be used to replace the JA-81M and JA-83M included magnets, and act as a more "invisible" alternative. The magnetic disk measures 10 x 4 mm.

Battery holder for 5 x C 1.5V batteries - for JA-80 / JA-180A.

Special battery belonging to Jablotron's outdoor IR detectors. Used in JA-150IR (4 pcs), JA-151IR (8 pcs), JA-180IR (4 pcs) and JA-80IR (4 pcs).

BAT-1V2-NIMH.1 is a rechargeable battery for JA-120N.

Technical specifications:
Battery type 1.2V NiMh AA BK-3MCCE 1900mAh Rechargable battery

Battery for backup in JA-150R repeater.

Technical specifications
Volt 4.8 V
Capacity 900 mAh

JA-107PWR is a spare part for Jablotron's JA-107 control panel. The power supply can replace unit in JA-107 if it should be defective.

Empty plastic housing that can be used for JA-150 control panel.

An alkaline LR14 C 1.5V battery.

This USB card reader makes registering RFID cards, in access control software, easy.