Jablotron tilbehør

JA-193PL-BOX-M is a medium wall mount box for JA-15.

The can enables you to mount a PIR detector, from the JA-1x1P series, sub-galvanized in brick and plaster walls. You can, with the accompanying frame, make the installation go hand in hand with the wall.

This box is size MEDIUM, but it is also available smaller (to match the different sizes of the PIR detectors) and the frames are available in white or gray.

The JA-150R is a wireless repeater from Jablotron, which in large JA-100 installations can extend the communication distance (up to 300 m) and increase operational reliability. The respect distance between repeaters is 10 m, and the number of repeaters is limited to the number of units in the control panel.

The following are supported by JA-150R : JA-15x and JA-18x detectors, JA-16xJ and JA-15xJ MS hand transmitters, JA-150N and JA-151N PG modules.

Technical specifications

AN-868-2PIN is an external antenna that enhances the 868 MHz signal to devices. The device has excellent transmission characteristics, as it is designed based on the special PIFA design, which is also found in the latest mobile phones. In addition, it has tamper detection if the power supply is short-circuited or disconnected. However, the function must necessarily be supported by the connected device. The antenna can be used both outside and inside. It is connected through a 2-pin connector, which is available in older and existing JABLOTRON 100 versions.

The following devices, from the JABLOTRON 100 series, are compatible with the antenna:

JA-151 A wireless two-way indoor siren
JA-151 N Wireless PG output relay 12/24 VDC
JA-150 IR Wireless active it. 2 Beam excl. Battery
JA-151 IR Wireless active it. 4 Beam. excl. Battery
JA-157 P Double zone outdoor curtain detector
JA-158 P Wireless outdoor detector

The AC-160-C is a wireless multifunction power relay to be used for the JABLOTRON 100 alarm system. When the relay is loaded into a central unit, it can be controlled via associated PG outputs. It has a switch relay with galvanically separated 230V / 16A supply.

Wireless devices can be loaded directly into the relay, so the device is used as an independent "system" that responds by activating one-way (indoor) wireless detectors in the JA-15x series - (JA-162J and JA-164J can also be loaded directly) .

The relay then triggers, according to the detector setting, one of five options: pulse, shift status, extended copy, off and block.

Technical specifications

The JB-150N-HEAD provides wireless control of the radiator valve. This is done by the thermostat head following the status from the selected PG output in the control panel.

Up to 32 thermostat heads can be installed independently of individual temperature gauges. It is important to have the correct adapter type as it must fit the radiator valve. The thermostat head is equipped as standard with a VA50 adapter that fits standard valves with the dimension M30 x 1.5. Four other adapters are available: JB-VA16, JB-VA26, JB-VA78 and JB-VA80.

The JB-150N-HEAD works by being connected to a thermometer or thermostat that is loaded in the control panel. In interaction, they do it i.a. possible to automatically switch to a more economical temperature, turn off the heat if you open a window, or make sure that a certain minimum temperature is maintained in the building. In addition, you can choose to be notified at too high / low temperature, you can choose to switch to manual temperature setting and you can even make a weekly schedule setting.

Technical specifications