facebook
  1. Home
  2. Alarm without subscription
  3. Jablotron

Jablotron JA-100

Jablotron JA-193PL-FSG GRAY frame SMALL for built-in box
Model: JA-193PL-F-S-G

JA-193PL-FSG is a small, gray frame for built-in box, intended for immersion of PIR detector. This frame matches the small can.

By: Jablotron
Jablotron PLV-P-ST (PTS) Mounting plate for ceiling
Model: PLV-P-ST

The mounting plate can be used to mount smoke or PIR detectors in the ceiling. The mounting plate is made so that it is easy to hide a cable under the device if you use BUS-based devices. For wireless devices, on the other hand, the mounting plate separates the antenna from the mounting surface, thereby improving the signal range.

By: Jablotron
Jablotron JA-150R Repeater
Model: JA-150R

The JA-150R is a wireless repeater from Jablotron, which in large JA-100 installations can extend the communication distance (up to 300 m) and increase operational reliability. The respect distance between repeaters is 10 m, and the number of repeaters is limited to the number of units in the control panel.

The following are supported by JA-150R : JA-15x and JA-18x detectors, JA-16xJ and JA-15xJ MS hand transmitters, JA-150N and JA-151N PG modules.

 

Technical specifications

excitement 110-230 VAC / 50-60Hz, class protected II.
Internal consumption Internal consumption, typical / maximum Approx. 0.5W / 1W (at 230 VAC)
Backup battery NiCd 4.8V (BAT 4V8 N900) 900 mAh, service life 4 years
Frequency 868.1 MHz
Range Approx. 300 m (open area)
Dimensions 132 x 182 x 45 mm
Operating temperature -10 ° C to + 40 ° C
Installation environment Indoors
By: Jablotron
Jablotron AN-868-2PIN External Signal Enhancement Antenna
Model: AN-868-2PIN

AN-868-2PIN is an external antenna that enhances the 868 MHz signal to devices. The device has excellent transmission characteristics, as it is designed based on the special PIFA design, which is also found in the latest mobile phones. In addition, it has tamper detection if the power supply is short-circuited or disconnected. However, the function must necessarily be supported by the connected device. The antenna can be used both outside and inside. It is connected through a 2-pin connector, which is available in older and existing JABLOTRON 100 versions.

The following devices, from the JABLOTRON 100 series, are compatible with the antenna:

JA-151 A wireless two-way indoor siren
JA-151 N Wireless PG output relay 12/24 VDC
JA-150 IR Wireless active it. 2 Beam excl. Battery
JA-151 IR Wireless active it. 4 Beam. excl. Battery
JA-157 P Double zone outdoor curtain detector
JA-158 P Wireless outdoor detector

Technical specifications
Frequency 868 MHz
Antenna strength improvement up to 3 dBi
Resistance 50ohm
Cable length 2 m
Operating temperature -20 ° C to + 60 ° C
Installation environment Indoors and outdoors
By: Jablotron
Jablotron AC-160 DIN wireless multifunction relay for DIN rail
Model: AC-160

Relay for mounting on YOUR rail

  • Wireless, 300 meters range
  • Supply 230V
  • Relay max 250V 16A
  • For lights, gates, bollards and other electrical appliances
By: Jablotron
Jablotron AC-160-C wireless multifunction relay for installation
Model: AC-160-C

The AC-160-C is a wireless multifunction power relay to be used for the JABLOTRON 100 alarm system. When the relay is loaded into a central unit, it can be controlled via associated PG outputs. It has a switch relay with galvanically separated 230V / 16A supply.

Wireless devices can be loaded directly into the relay, so the device is used as an independent "system" that responds by activating one-way (indoor) wireless detectors in the JA-15x series - (JA-162J and JA-164J can also be loaded directly) .

The relay then triggers, according to the detector setting, one of five options: pulse, shift status, extended copy, off and block.

The relay takes up a space in the system.

Technical specifications

excitement ~ 230 V / 50 Hz, protection class II
Internal power consumption 0.4 W / max. 1.5 W
Max. excitement 250 V AC / 24 V DC
Resistance load Max. 16 A
Inductive, capacitive load Max. 8 A
Halogen lighting Max. 1,000 W
Minimum DC current 0.5 W
Wire cross section Max. 2 x 1.5 mm2
By: Jablotron
Jablotron JB-150N-HEAD Wireless control of radiator valve
Model: JB-150N-HEAD

The JB-150N-HEAD provides wireless control of the radiator valve. This is done by the thermostat head following the status from the selected PG output in the control panel.

Up to 32 thermostat heads can be installed independently of individual temperature gauges. It is important to have the correct adapter type as it must fit the radiator valve. The thermostat head is equipped as standard with a VA50 adapter that fits standard valves with the dimension M30 x 1.5. Four other adapters are available: JB-VA16, JB-VA26, JB-VA78 and JB-VA80.

The JB-150N-HEAD works by being connected to a thermometer or thermostat that is loaded in the control panel. In interaction, they do it i.a. possible to automatically switch to a more economical temperature, turn off the heat if you open a window, or make sure that a certain minimum temperature is maintained in the building. In addition, you can choose to be notified at too high / low temperature, you can choose to switch to manual temperature setting and you can even make a weekly schedule setting.

Technical specifications

Power supply 3 alkaline batteries AA (LR6) 1.5 V / 2.4 Ah Batteries are not included in the product package.
Typical service life 2 years - 2 heating seasons (at 10 cycles per day)
Communication frequency 868.1 MHz, JABLOTRON protocol
Communication range 300 m (line of sight)
Dimensions 85 x 49 mm
Weight 105 g
Operating temperature range -0 ° C to + 60 ° C
By: Jablotron
Jablotron PLV-JA 63/82/100/101/103 Empty plastic box
Model: PLV-JA

An empty plastic box, measuring 25.7 x 22.2 x 7.8 cm. Can be used for Oasis and Profi alarms, or for installation of ATU.

By: Jablotron
Jablotron AN-05 2G-3G GSM Antenna with magnetic base 26cm
Model: AN-05

AN-05 is a GSM antenna with 800-2100MHz. + 4dB. It is a long pole antenna that has an extension coil on a magnetic base. The antenna must be used to move the receiver position too centrally, to a place with better signal strength, and thus does not have appreciable gain.

Specifications:
Cable length of 3 m
SMA plug
Length 26 cm
Possibility of extension 2m, 5m Coax cable RG-58U
Mounting magnet

By: Jablotron
Jablotron AN-06 GSM Antenna with glue for Jablotron and Satel
Model: AN-06

AN-06 is a self-adhesive print antenna in plastic packaging.

It is made to be mounted in a plastic box, next to the transmitter module.

Specifications:
Cable length of 30 cm
SMA plug
Length 26 cm
No possibility of extension
Self-adhesive mounting

By: Jablotron
Jablotron GBT-212 tester for glass break detector
Model: GBT-212

Test unit that can be used for simple testing of glass break detector.

By: Jablotron
Jablotron JS-7904 Corridor lens for Jablotron detectors
Model: JS-7904

JS-7904 is a corridor lens for Jablotron's JA and JS PIR detectors. It has a range of 25 meters.

Also note that the lens is not compatible with Jablotron's JA-111P xx and JA-151P xx series.

By: Jablotron
Jablotron JS-7910 Pet lens for Jablotron detectors
Model: JS-7910

JS-7910 is a lens for Jablotron's JA and JS PIR detectors. The lens is for people with pets, so the PIR detector is not disturbed by the pet's movements on the floor. If you install it at a height of 2.5 meters, there will be a free area 7 cm above floor level 7 meters outside.

Please note that the lens is not compatible with Jablotron's JA-111P xx and JA-151P xx series.

By: Jablotron
Jablotron JS-7902 Curtain lens for Jablotron detectors
Model: JS-7902

JS-7902 is a curtain lens for Jablotron's JA and JS PIR detectors.

Please note that the lens is not compatible with Jablotron's JA-111P xx and JA-151P xx series.

By: Jablotron
Jablotron LD-81 Water damage detector for JA-100, OASIS and PROFI
Model: LD-81

LD-81 is a water damage detector that is placed in risk areas, eg under the kitchen sink, or other places where water leaks may occur. Using the detector, water leaks can be detected before the situation escalates and permanent damage occurs. The operating temperature of the detector is -10 to + 40 ° C.

The LD-81 detector works with one of the universal transmitters for either JA-100, Oasis or Profi. It does not need a power supply, but is connected to the JA-105M / JA-81M / JA-16N magnet, which acts as a transmitter to the control panel.

 

 

 

By: Jablotron
Jablotron EI208W stand-alone carbon monoxide detector (CO)
Model: EI208W

EI208W carbon monoxide detector, which can be used indoors in buildings, caravans and boats. The detector is designed to warn of the accumulation of carbon monoxide (CO), with LED lights and siren sound.

The device is supplied with power from an integrated lithium battery, for the entire life of the device (7 years - expiration date can be found under the device).

If you want to expand, there are several options to suit the detector: GS-208-CO wired module, JA-110G-CO JA-100 BUS module and JA-150G-CO JA-100 wireless module.


Supply voltage: Integrated non-replaceable lithium battery
Battery life: the entire life of the device
Temperature range: -10 ºC to +40 ºC
Humidity: 15% to 95% (non-condensing)
Dimensions: 120 x 105 x 40 mm
In accordance with EN 50291-1

By: Jablotron
Jablotron JA-M Magnet disk 10 x 4 mm
Model: JA-M

Magnetic disk (and associated screw) that can be used to replace the JA-81M and JA-83M included magnets, and act as a more "invisible" alternative. The magnetic disk measures 10 x 4 mm.

By: Jablotron
Jablotron BH-80A Battery holder for JA-80 / JA-180A for 5 x C 1.5V batteries
Model: BH-80A

Battery holder for 5 x C 1.5V batteries - for JA-80 / JA-180A.

By: Jablotron
To Top